Production process of toothbrush embroidery

Toothbrush embroidery is a new type of embroidery that has appeared recently. It is in the ordinary embroidery process, add a certain height of accessories (such as EVA) to the fabric, after the embroidery is completed, use a tool to repair the embroidery thread on the EVA, remove the accessories, and form an embroidery with the same shape as my toothbrush. Next, let's take a look at the introduction of the toothbrush embroidery production process.

Methods and steps:

1. According to the size of the pattern, use the opening belt to open a single line on the sand net.

2. Cut off the sand net along the outer frame of the single line, and paste double-sided adhesive along the perimeter of the cut hole for three-dimensional glue.

3. According to the size of the fabric, add a circle of double-sided tape for pasting the cloth.

4. Put a layer of sand net before pasting the three-dimensional glue to prevent the embroidery thread from falling into the three-dimensional glue during embroidery.

5. Paste the three-dimensional adhesive on the double-sided adhesive, and at the same time, in order to facilitate embroidery, you can also add a layer of wax paper on the three-dimensional glue.

6. Stick the fabric back side up on the double-sided tape.

7. Put a layer of ironing on the embroidery area, and then carry out embroidery.

8. After the embroidery is completed, use iron and other tools to make the iron hot dissolve and dip on the embroidery thread to prevent the embroidery thread from loosening after processing, or you can use ironing to prevent the embroidery thread from loosening after processing.

9. The ironed embroidery products are reversed for processing, just cut off a layer of sand net on the surface and then take away the three-dimensional glue to get the toothbrush embroidery effect, mass production using toothbrush embroidery special sheet skin machine for processing.

10. The peeling thickness of the sheet skin machine can be adjusted according to the requirements, and the usual peeling range of the machine: 0.6~8mm.